Hyper Grounding Kits for Trucks, Save Fuel and Money

What Is Strapping 4 Engines?

Simply put, Strapping 4 Engines is a highly sophisticated grounding system that when properly installed to an engine, redirects the static electricity that is normally found in engine components, back to the battery. Allowing these critical engine components to be freed up from excess electricity and run more effectively.

Strapping 4 Engines can be applied to just about any fuel based engine (gasoline or diesel) including generators, and is especially effective on high mileage, high hour engines. Any engine will benefit from this extremely effective system.

After installation, owners have found...

Engine Runs Smoother
Dramatically Extends Engine Life
Saves Wear on Electrical Equipment
Increase in MPG
Increase in Horse Power
Increase in Torque
Cleaner Emissions
Smoother Transmission
Increased Battery Life
Stronger Radio Signal

Typical installation takes 2-3 hours, and is done by one of our factory trained technicians. Not all engines are the same, and newer engines may not experience the extreme MPG & HP gains, but just about any engine will benefit, generally recouping cost of installation in just 2 months!

Sounds Good... Order Now

Truckers are you serious about cutting your fuel costs?

Are you serious about lowering green house gasses?

Every truck we have installed "STRAPPING" on has accomplished two things.

1). They lowered their Fuel Cost.

2). Exhaust smoke has either completely stopped or lowered significantly.

That only means one thing. Helped the environment.

What is Strapping?

It is a series of specialized cables installed on your engine to reduce and or remove your engines static charge.

What does it do?

Your engine when running is spinning, from the fan up front to the crankshaft, pistons moving up and down, flywheel spinning and transmissions gears spinning as well.

So what, you say. It's called static and electrical charge, created by perpetual motion. Oh what will they think of next? I don't know, but if I can take cables, install them in strategic points on the engine and drive line to reduce the engines drag (Yes drag) it will do several things.

1.) Your engine will run smoother

2.) It will create a smoother, cleaner electrical signal to the engines computer

3.) It will help clean your engine, reducing emissions

4.) Increases engine torque, helping to reduce fuel costs

5.) Helps your electrical system to last longer

6.) Starter, Alternators, Batteries last longer

7.) Saves the life of onboard computers and GPS devices

8.) Starts easier and faster

9.) Engine is quieter

10.) Engine is smoother

11.) Reduced friction, helps cold weather starts

12.) Does not interfere with warranties

Your drivers won't believe the difference. They will compliment the mechanics for the great tune up.

How much fuel can I save?

Well I am not going to sit here and tell you 20% or 30% and blow smoke, but I will say without even knowing what kind of engine you have I will guarantee 4% or more. Yes I do have Cat's C-15's gaining 20% and another at 50% but they were in pretty sad shape. 4% was consistently done on almost brand new Detroit DD515 engines, 2010 models. Some say they are the most fuel efficient engines. Miles per gallon increase from 4/10 of a mile to 1 mpg average. I have proved it time and time again. The chart Below gives you a quick break down of possible savings.

How much does it cost?

NOTE: Please contact us prior to any International Orders, Foreign models are different than USA versions and may need to be adjusted accordingly. Shipping is FREE in the USA. All orders shipped outside the USA will include an additional $30 Shipping Fee, which is reflected in total.

I do not offer any kits for Marine Applications, because of special grounding requirements. We do all marine installs our self's. If you are not familiar with the grounding characteristics of marine power units, please do not attempt this, as it can cause serious injuries.

I know trucking companies get bombarded daily with fuel saving "Who Do". That is correct I call it "Who Do". Fuel additives, air cleaners, you name it, your maintenance team has got it.

Strapping 4 Engines is nothing like you’ve seen before. All our cables are high density Marine cables and sealed against weather damage. Why don’t they do this from the factory? Well that’s simple, all they care about is build it, if it starts, ship it. This would take them too much time and labor for the manufacturer to complete. I’ve witnessed trucks being delivered from the factory without a battery installed. What does that tell you?

If your fleet is based in the snow belt or runs in the muck and mire on a consistent basis and is 2 years of age or older, this will revitalize your equipment. Your drivers will wonder what you did to their trucks.

Do you know that after one year a truck will loose 75% of it’s ground from weather? This can kill the engine mapping computers. Just to clarify, I do nothing with the computers. No programming is hampered with, engine settings are not touched. Matter of fact, I don’t even connect to the positive side, so how can it hurt anything.

For example everyone is now buying trailer skirts. This cost approximately $1500.00 a set, plus install and maintenance, for a return that takes years to recoup. Oh yes, and they must have a trailer mechanic. For about half of that and again Zero Maintenance, this process will save you much more.

Read Our Testimonies then Contact Us Today

It might just be another diesel engine, whether it’s the 4 cylinder or a 2 cylinder it still has a pretty tough load factor. Constantly turning the compressor and pumping the refrigeration, takes a toll on these small engines. Strapping 4 Engines takes a lot of the load off the engine, freeing it up to do its job. Less engine friction and static, increasing the engines life, as well as other components, increasing the life span and lowering maintenance costs.

Contact Us Today

If you haven't already heard, Going Green is all the rage! Now farmers can jump on board with one simple step!... Strapping 4 Engines is a fantastic way for farmers who would not only like to Go Green, but Save Money in the process.

What is Strapping 4 Engines you Ask?

Simply put, Strapping 4 Engines is a highly sophisticated grounding system that when properly installed to an engine, redirects the static electricity that is normally found in engine components, back to the battery. These critical engine components can then be freed up from excess electricity and run more effectively.

Strapping 4 Engines can be applied to just about any fuel based engine (gasoline or diesel) including generators, and is especially effective on high mileage, high hour engines. Almost any engine will benefit from this extremely effective system.

After installation, owners have found...

Not all engines are the same, and newer engines may not experience the extreme MPG & HP gains, but just about any engine will benefit, generally recouping cost of installation in just 2 months!

Contact Us Today and find out if Strapping 4 Engines is right for you...

It's time to "Go Green and Save Money"!

Whether you’re operating a 25’ pleasure craft or a 200’ fishing vessel, Strapping 4 Engines can help lower the gallons per hour usage.

Fishing Boat with MTU Power

Whether it’s a Volvo, Yanmar, Cummins or Cat we can help make them run smoother, give you quicker response on the throttle, and best of all reduce your GPH.

With our location being 100 miles from the South Carolina Coast, we are located in the heart of Shrimping country. With decreasing profits and competition from foreign vessels, operators need to do everything possible to lower their operating cost.

"No need to be coast guard approved"

CONTACT US TODAY

Link Bar

What Is Strapping 4 Engines?

Truckers Go Green and Save Money

Fleet Truck Operators Go Green and Save Money

Refrigerated Trailers Go Green and Save Money

Farmers Go Green and Save Money

Boaters Go Green and Save Money

Link List